|
Witch Hunters  |
Witch Hunters - DaemonhuntersInquisitorial Stormtroopers Repressor TransportOne of the resin parts that comes with the Repressor kit is the visor for the driver. Basically it is the same as the plastic part, but with a banner attached.
As I was building the Repressor I noticed that I had a problem. The new roof did not fit as expected, it was as though it had shrunk.
The arrow points to the parts not fitting together as they should. This is of course always a concern with resin parts and to be honest I almost expect it with Forgeworld models, these are resin kits which require skill not mass produced plastic kits which any old fool can put together! This shot shows the front.
Now the issue was how was I going to rectify this?
As I thought about it, I decided to make up the frontal storm bolter turret. These are the resin and plastic components.
Here is the completed turret.
It fits nicely into the turret ring. |
 |
This page was last updated on the 13 December, 2007
|
|
 |
||||
 |
|
|
